Panasonic NC-ZA1 Mode D'emploi page 23

6
Press
(e.g.: When cappuccino is selected)
Time bar is increasing according to process.
Wait until display shows
to remove the cup(s).
(simple rinsing)
7
Fill a glass with clean water and press
• This cleaning cycle is for next drink preparation without milk residue.
• Switch the milk hose from milk package to the glass and set the empty cup under the dispenser. (Cup size > 250 mL)
The display will return to the main menu
when the rinsing cycle is completed.
Q To turn off the power after use « P. GB27
to start brewing.
Note
• Be careful with steam coming out after
is pressed.
• If is pressed during the brewing process, it immediately
stops the process.
After flashes, the display will move on to step 7.
• If the temperature of the water is not sufficient to brew coffee, the
heating up process will be performed first.
• When brewing cappuccino or Latte Macchiato, the display shows as
follows.
Between brewing milk and coffee, brewing will
be paused.
• If surface of milk is higher than the spouts position, it may cause milk
to drip from the dispenser. In that case pull out the milk hose.
to start rinsing.
Note
• If you prepare milk menu continuously, skip this cycle by pressing
.
• If is pressed during the rinsing cycle, it immediately stops
the process.
After flashes, the display will return to the previous display.
GB23