Ibiza sound LP300 Manuel De L'utilisateur page 5

12– USB SOCKET
Plug USB device. The USB lead length is limited to 3m.
13– Ground
Ground lug for turntable connection. Always use this connection when using turntables (your turntable cable should have
a grounding wire).
14– Power cable
This power cable should be plugged into a wall receptacle AFTER all audio connections have been made.
15– USB & SD
Plug USB stick and SD card into these slots. The LED will light during operation.
16– Audio select
This button selects the source to listen to. In order to record/listen to a vinyl the LED "PH" must be lit.
17– REC STOP/START
This button(de) activates record function. In order to record a vinyl the LED besides this button has to be lit
18– Skip button (+/-)
Press it to select the any one track of the USB stick and SD card.
19– REC GO
Each press of this button toggles PLAY/PAUSE during playback from USB or SD. In addition, this button starts and
pauses recording of the vinyl to SD/USB when record is armed before (see 17)
20– REC volume
Used to adjust the level of volume which will be recorded.
Warning: Incorrect platter setup can lead to poor turntable performance, platter instability or permanent motor
damage.
1. The rubber belt has been pre-installed onto the turntable platter. However, please turn the platter over and make sure
that the belt is attached and is not twisted. If the belt has come off during shipping, please place it around the inner bottom
ring of the turntable platter, as shown in NO. 1 above.
2. Place the platter on the center spindle and press it down firmly. Rotate the platter until the brass motor spindle is visible
through one of the holes. Check to make sure that it rotates uniformly and does not wobble excessively.
3. Pass your fingers through the hole, grip the rubber drive belt and install it over the motor spindle. Be careful not to twist
the rubber drive belt during this step. Check to make sure the platter rotates uniformly. If the drive belt is properly installed,
there should be a slight amount of tension that brings the platter to a stop after spinning it freely.
©Copyright LOTRONIC 2014 LP300 5