Error Codes - Danby Designer DUF140E1WDD Manuel Du Propriétaire

TROUBLESHOOTING
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
No power
Internal temperature not cold enough
Appliance runs continuously
Internal temperature is too cold
Noises

ERROR CODES

• E2: Temperature sensor failure.
• E5: Defrosting sensor failure.
• E6: Communication failure.
• E7: Ambient temperature sensor failure.
• E9: High temperature.
Danby Consumer Care: 1-800-263-2629
• A fuse may be blown or the circuit breaker tripped
• Plug not fully inserted into the wall outlet
• Temperature setting is too warm
• Door is not shut properly or opened excessively
• Exhaust vent is obstructed
• Recently added a large quantity of warm food to the cabinet
• Close proximity to heat source or direct sunlight
• Ambient temperature or humidity is very high
• Appliance is set to run as a refrigerator instead of a freezer
• Temperature setting is too cold
• Door not shut properly or opened excessively
• Exhaust vent is obstructed
• Recently added a large quantity of warm food to the cabinet
• Close proximity to heat source or direct sunlight
• Ambient temperature or humidity is very high
• Temperature setting is too cold
• Appliance is set to run as a freezer instead of a refrigerator
• Parts are expanding and/or the refrigerant is circulating;
this is normal
7
POSSIBLE CAUSE