iComfort ic2000 Manuel D'utilisation page 4

3) Cup holder installation
Take the chair out of the packing carton (Figure 1). Take out the cup holder support bracket
from the accessory bag, align with the mounting screw hole reserved for the right armrest, then screw
the 2 M4X10 screws into the massage chair right side armrest with the cross screwdriver, and pull out
the male USB cable from the right armrest of the massage chair (Figure 2).
Fig. 1
Take out the upper cover of the cup holder from the accessory bag, aim the slot of the upper cover to
the limit board, prepare to insert (Figure 3). Press the upper assembly down to insert it into the limit
board and make sure it is pushed all the way (Figure 4).
Fig. 3
Make sure the cup holder is installed well. Then, twist 2 M4*10 screws with the cross screwdriver and
fix the cup holder upper assembly on the right side of the armrest (Figure 5). Connect the male USB
cable to the USB female wire which is on the cup holder upper assembly (Figure 6).
Fig. 5
Fig. 2
Fig. 4
Fig. 6