Intended Use; Using The Sander - PEUGEOT EnergySand-140D Manuel D'utilisation

Sander's description
Handle
01
On/off switch
02
Sanding pad
03
Sanding paper 140x140x90mm
04
Vacuum adaptor
05
Operating instructions

INTENDED USE

The machine is intended for dry sanding of wood, plastic, filler and coated surfaces.
FITTING THE SANDING PAPER (4)
Fit the 140x140x90mm sanding paper over the pad in order it covers the entire surface. Make
sure the sanding paper matches with the edges of the pad and that the dust collection holes in
the pad and sanding paper holes are well aligned. Never use your sander without a sanding
paper.
USING THE VACUUM ADAPTER (5)
Your sander is equipped with a vacuum adapter, which is designed for collect dust task. Insert
the vacuum adapter into the rear dust outlet of sander. Then pull the vacuum adapter and make
sure it is tightened securely on the dust outlet. Then connect the hose of a vacuum cleaner.
First please turn on the vacuum cleaner, then turn on the sander. If you stop sanding, first turn
off the sander, then turn off your vacuum cleaner.
OPERATING THE SWITCH (2)
To start the tool, press the on/off switch to "I" ON position. To stop, press the switch to "O"
OFF position.

USING THE SANDER

Your sander is equipped with a teardrop base which allows you to use it on large flat surfaces,
as well as difficult and confined areas. The workpiece to be sanded must be secured. If it is
small or it may move during sanding, it must be held in a vice or suitably clamped. Be sure
to hold the sander firmly while it is on and apply it gently to the work, it may "kick" on first
contact. Hold the sander so that it is flat on the work and move slowly, preferably with
a smooth, circular motion. Regularly check the condition of the sanding paper and replace
when torn for best results.
150703-Manual-A.indd 5
EN
1/03/13 15:49:50