Technical Data - OXO SparkJet U1 Mode D'emploi

F - W-DMX
Sparkjet U1 is compatible with W-DMX from Wireless Solution Emitter.
To activate W-DMX, you have to push the W-DMX ON/OFF button on the top left corner of the
rear panel.
Then you have to pair your Sparkjet U1 with your W-DMX emitter.
The LED status will indicate the state of the wireless :
Not Paired : fixed White
Paired but not connected to emitter : blinking fast in red
Paired and connected to emitter but no DMX : blinking slow in green
Paired, connected with DMX : fixed green
To unpaired, push pairing button during 5s, the LED should blink and go to fixed white.
Then to pair the Sparkjet U1 to an emitter follow the instruction of your emitter
G- Remote control
To use the remote control, first check that W-DMX is OFF, then plugged the remote into DMX
input.
Wait that the machine is ready to sparkle and just push the button to get the effect
If you want to use 1 remote with several Sparkjet U1, you could daisy chain up to 4 Sparkjet
U1 thru DMX IN and OUT with 5 wires DMX cable. (USITT 1990 - 5 Wires).

5. Technical data

Voltage
Power Consumption
Control
DMX Control Channels
IP Grade
Working Temperature
Product dimension
Product weight
User Manual - SPARJET U1
240VAC, 50Hz
700W
DMX / W-DMX / Wire Remote
1 CH
IP20
0-40°c without condensation
20 x 20 x 26 cm
7,8 kg
V1.2 09/2018 8/16