Chair Set Up; Basic Settings; Basic Equipment - Thomashilfen ThevoMulti Manuel D'utilisation

Chair Set Up

After you have unpacked the ThevoMulti it just needs to be plugged in. Do this as follows:
1. Check that the power plug and the ThevoMulti cord are each plugged into the transformer.
2. Then check whether the cord from the hand control is connected with the motor of the ThevoMulti.
3. Connect the power plug to the power supply.
Now your ThevoMulti is ready to use. If the ThevoMulti is lifted by its side parts after set up, the backrest might
fold back. This is because of its design and is not a product defect. To prevent this from happening, support the
backrest of the ThevoMulti whenever you lift it.

Basic Settings

Use the hand control to change the position of the ThevoMulti. The hand control has two buttons. After attaching
the back rest, the ThevoMulti is in a high position.
To return to the base position, use the right button (red symbol) on the hand control. Press down on the button until the
ThevoMulti reaches the starting position. (Picture 2)
To move the ThevoMulti from the base position to the standing up position, press down on the left button (blue symbol)
on the hand control. The ThevoMulti will then go into a higher sitting position. (Picture 3) At this point it is still possible
to use the revolving function.
Then the ThevoMulti goes into the position for standing up. (Picture 4) At this point the revolving function locks.
To reach the resting position press down on the right button (red symbol) on the hand control. After reaching the base
position, the backrest reclines until the seat is in the resting position. (Picture 5)

Basic Equipment

Attaching the cover for the base of the chair
You can attach the cover for the base of the chair as follows:
1. Carefully tip the ThevoMulti on its side and put on a clean underlay.
2. Undo the 4 zippers of the cover.
3. Pull the cover over the base of the chair making sure that all the feet are visible
and then do up all the zippers.
4. Adjust the cover so it is even.
5. Carefully stand the ThevoMulti up again. – Done
Attaching the neck support pillow
On the neck support pillow there is a strip of material weighted at the end. To attach the neck support pillow to the
ThevoMulti, proceed as follows:
1. Position the neck support pillow in the head area of the backrest of the ThevoMulti. When doing so, the strip
of material on the underside of the neck support pillow has to be facing up.
2. Put the strip of material over the backrest of the ThevoMulti. It should hang down from the backrest
of the chair.
3. The neck support pillow is simply adjusted in height for ideal positioning . (Picture 11)
10