Elesa DD52R-E Mode D'emploi page 22

DD52R-E
7.4 Direct programming of the absolute reference value (source) – of the
compensation value (offset) – of the reading after one revolution
The function of the keys combination allows direct access to the
+ programming of one of the following parameters, depending on the
value assigned to parameter 0 _ _ _ _ 0 .
0 _ _ _ _ 0
The available options are:
- P_OrG : direct programming of the absolute reference value (OrG parameter)
- P_StP : direct programming of the reading after one revolution (StEP
parameter)
- P_OFS : direct programming of the compensation value (OFFS parameter)
- OFF : the keys combination
the operating mode
For programming the parameters listed above see parameter 0 _ _ _ _ 0 of
paragraph 8.2.
7.5 Programming target position
The function of the keys combination allows, if the parameter 0 _ 0 _ _ _ has
been set on tArGEt , to program or to load one of the 32 target positions.
0 _ 0 _ _ _
The available options are:
- LOAd_t : choose one of the 32 available target positions, then press
confirm
- PrOG_t : choose to program one of the 32 available target positions,
then press
EN
22
It is possible to change the function of the keys combination
by setting the parameter 0 _ _ _ _ 0
+
It is possible to change the function of the keys combination
by setting the parameter 0 _ 0 _ _ _
to start programming
Direct drive electronic position indicators
is not associated to any function in
Models all rights reserved in accordance with the law.
to
Alw