Burg Wächter TSE Control Instructions De Montage page 6

Please read the operating and installation instructions for your device carefully before
switching on.
IMPORTANT:
All guarantee rights shall be void in the event of incorrect installation.
Burg-Wächter KG reserves the right to carry out changes to the product, technical data and
the operating instructions without prior notification. Please read the operating instructions
carefully before using this device.
Installation should only be carried out with appropriate qualified knowledge.
The TSE Control unit is not designed for outdoor installation and, consequently, should not be
subjected to any direct weather influences. If required, the TSE Stainless Steel Cover (art. no.
54680) can be attached to protect against vandalism and moisture. For this reason, we
recommend installation in a secure area if using for security-related appliances.
IMPORTANT:
The maximum radio range of the TSE Control unit in connection with the E-key is max. 10 m
in an open area. The actual range depends on the surroundings and can therefore vary
considerably.
A test must be carried out before screwing/sticking the TSE Control unit into place to ensure
that radio reception is actually possible for the TSE Wireless Control Unit in the required
position. Observe the Switch LED in this case. If the TSE Wireless Control Unit has no radio
reception (the device does not operate when the button on the E-key is pressed), choose a new
position about 10 cm away and try again. Repeat this procedure until radio reception has been
established.
You can fasten the TSE Control unit in place using either the adhesive pads or the screws.
After this, lay the cable and screw the connections tight onto the provided terminals. Finally,
establish power supply and clip the cover onto the base plate.
dp/hbg 20081021 TSE Control 6