Important - Burg Wächter TSE Control Instructions De Montage

TSE Control
Thank you for choosing the TSE Control unit. With the TSE Control unit, you have the
possibility of controlling electrical equipment using the TSE E-keys. To do so, the appliance
to be switched on/off must be connected to the TSE Control unit.
For the necessary power supply, you have the choice between simple battery operation (2 x
MIGNON LR6, AA 1.5 V Alkaline or, alternatively, 2 fully charged NiMH or NiCd
rechargeable batteries) and a separate power supply unit with a voltage range between 6 V
and 24 V DC. With the power supply unit, it is possible at the same time to maintain full-
charging of the rechargeable batteries which can serve as emergency power supply in the
event of combined connection. Please note that a simultaneous use of a power supply unit
and the non-rechargeable batteries (LR6) is not permitted.

IMPORTANT:

Before fitting the electronic TSE Wireless Control Unit, please change the existing
administrator code (works setting: 123456) using the PC software or an input unit.
The LEDs on the front side show the switched state (Switch) of the TSE Control unit on the
one hand and the voltage level (Energy) on the other.
The Switch LED flashes at short intervals if you activate the TSE Control unit continuously
for a longer period of time. If the Energy LED is flashing, check the power supply or change
the batteries.
The following connections are available:
• + 6 V – 24 V
• - GND
• COM
• NC Make contact
• NO Break contact
IMPORTANT: No voltage of 230 V may be applied via the relay!
The power supply unit is connected (if required) using the +/- terminals. There is a potential-
free break contact between COM and NC and a potential-free make contact between COM
and NO.
dp/hbg 20081021 TSE Control
(max. 24 V, 2 A)
(max. 24 V, 2 A)
5