Getting Started; Remote Control - Hama PR-2180 Mode D'emploi

5. Getting Started

5.1 Remote control

• Open the battery compartment cover. It is located on
the rear of the remote control.
• Pull the closing tab back (if present) and lift the cover.
With other models of remote control, it suffices to
simply push the casing in the direction indicated.
A:
Closing tab
Insert the batteries, paying attention to match the
polarities correctly. The correct polarity is indicated
by the plus and minus symbols in the battery
compartment.
5.2 Speaker
• Connect the two satellite speakers with the
corresponding audio outputs at the rear of the
subwoofer, as shown in the wiring diagram Point 4.
• Then connect the corresponding AUX audio input
with the signal source (computer/DVD/Blueray/MP3
player etc.), with the help of one of the enclosed
audio cables.
• Connect the subwoofer's power supply cable to an
undamaged electrical socket which has been installed
correctly.
4
B:
Sliding cover
Note
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• When using a mult-socket power strip, make sure
that the sum power draw of all the connected
devices does not exceed its maximum throughput
rating.
• If you will not be using the product for a long
period of time, disconnect it from mains power.
Note – Line interference / reception
problems
• In an environment with radio-frequency
disturbances, the sample may malfunction
and could self-recover when the interference
disappears.
• In an environment with conducted disturbances,
the sample may malfunction and could self-recover
when the interference disappears.
5.3 On/off switch / standby
• Turn the speaker system on by turning the on/off
switch ON/OFF at the rear of the subwoofer to ON.
• Turn the speaker system off completely by turning
the on/off switch ON/OFF on the rear side of the
subwoofer to OFF.
• When the speaker system is turned on press
the POWER button on the remote control or the
MODE button on the subwoofer's front display for
approximately 3 seconds to switch the speaker system
to standby mode.
• Press the POWER button in standby mode on the
remote control or the MODE button on the front
display of the subwoofer to activate the speaker.