Astralpool AspiD Manuel D'installation Et D'entretien page 5

CHANGING AND REPLACING THE MAT
7. TROUBLESHOOTING
PROBLEM
The ASPID
does not work
The ASPID
moves very slowly and bubbles of air
appear in the return nozzle
The ASPID
is stuck in the ladders and in the steps of
the ladders
1. Lever off the upper shell using a screwdriver
2. Lift the cover of the suction cavity
3. Unclick the two pivot pins
4. Pull under the ring and replace the mat (4406012101)
5. Click the ring, shoe and mat to the main body bearing in mind that there is only one
position
Place the cover and the upper shell ensuring that they are well fastened
Reinstall the ASPID and start-up the pump
Check that the ball is not blocked. If it is, unblock it so that it can move freely inside the suction
cavity.
Check the flow using the flow metre
is insufficient:
IF THE
FLOW
is correct:
Check the water tightness of the circuit: between the apparatus and the hose, between all
sections of the hose, between the hose and the valve, between the valve and the skimmer.
Place the deflector in the best position to avoid blocking and let it adapt to the shape and the
obstacles of the swimming pool.
This problem can be solved in some cases by connecting the hose to the suction intake or the
skimmer that is furthest away from the ladder, or cut 1 section of hose to stop it reaching the
steps
5
SOLUTION
Check that the drain valve is properly closed.
Check that the filter and skimmer basket are perfectly clean.
Check that the hoses and flow valve are properly connected.
Check that the suction system of the apparatus is not blocked.
Check that the ball is not blocked.