Battery And Charger - Albatross A1 Instructions D'utilisation

Straight-ahead setting
In 3 Steps
If the albatross does not run straight, carry out the following step:
1. Loosen the front wheel nut.
2. The straight running can be adjusted by turning the two small Allen screws on the inside
and outside.
3. Tighten the wheel nut again after successful adjustment.
1.

Battery and charger

Correct handling
• Before using the trolley for the first time, the battery must be charged for 8 hours without
interruption using the supplied original charger.
• First connect the charger to the power grid and then connect the battery to the charger.
• The charging process will be complete as soon as the LED on the charger lights up constant-
ly green.
• Ideally, the battery should be fully charged after each use.
• Disconnect the charger from the battery if the charger is not connected to the power grid.
• The battery may only be charged in well-ventilated and well-tempered rooms (not below 5 °
C or above 35 ° C). The charger should not be covered during the charging process.
• During winter breaks or longer interruptions, disconnect the fully charged battery from the
charger and recharge after 2 months and disconnect it from the charger again. Then dis-
connect the charger from the power grid.
18
2. 3.