LENCO LS-100 Mode D'emploi page 8

1. Turn on the unit by the POWER/VOLUME Knob.
2. When the turntable is switched on and the tone arm is placed on the arm rest, Bluetooth mode is automatically
activated and go to pairing mode, LED light would flash
3. The first time you use your Bluetooth device with the turntable, you will need to pair them together.
4. Turn your external device's Bluetooth Setting ON. Wait a moment, then look for the Bluetooth pairing name "Lenco
LS-100". If your device asks for a password (depending on the device manufacturers, model, and software version),
then enter digits "0000" and press OK.
5. Select the Bluetooth pairing name, to connect the unit. Once connected, the Led light will stop flashing.
6. You are now connected to your external device via Bluetooth
7. Rotate the Volume Control Knob to adjust the sound level and adjust the volume control at your external audio device.
"This product has a bluetooth reception function, you can not transmit any bluetooth sound with it: this means that you
can receive wirelessly a bluetooth sound signal from an external source like a smartphone."
Listen to auxiliary input
1. Using a 3.5mm Stereo cable (not included), connect an external audio device to the AUX IN socket at the back of the
unit.
2. Turn on the unit by the POWER/VOLUME Knob and adjust the volume to an appropriate level.
3. Use the POWER/VOLUME KNOB to adjust the volume and use the controls on the external audio device to control the
Playback/Volume functions
Note: When the Aux jack is inserted with cable, the LS-100 would stay at Aux mode, you have to unplug the cable to exit
the Aux mode if you want to listen to record or Bluetooth music
Automatic stand-by for power saving (CE regulation): The LS-100 will go automatically in standby if there is no audio
signal (record or Bluetooth) during +/- 15 minutes. To re-activate the device, you have the choice below:
⚫
Move the tone arm to the turntable platter with record to start playing.
⚫
Turn the POWER/VOLUME Knob to OFF and ON again.
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction "A".
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction "B".
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
Guide Pins (inside)
8