Silverline 802165 Mode D'emploi page 10

GB
Troubleshooting
Problem
No function when On/Off Button
(2 & 3) is operated
Cutting Disk (5) is making strange
noises/vibrating/not performing
straight cuts
The Cutting Disk is wearing
excessively and a burning smell is
being produced'
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
10
Possible cause
No power
Defective On/Off Button
Loose spindle locking nut
The Cutting Disk is not seated on the inner flange correctly
The Cutting Disk is too worn/warped from excessive use
Insufficient amount of water in the Water Sump (1)
Cutting Disk is too worn to effectively dissipate heat
Solution
Check power supply
Replace the On/Off Trigger Switch at an authorised Silverline service centre
Ensure that the blade is correctly fastened to the spindle, see 'Replacing the
cutting disk'
Check the Cutting Disk is seated on the inner flange correctly so that it runs safe
and true, see 'Replacing the cutting disk'
Replace the Cutting Disk, see 'Replacing the cutting disk'
Refill the Water Sump
Check and replace the Cutting Disk, see 'Replacing the cutting disk'