Alesis TransActive 50 Guide D'installation Rapide page 9

Using a Pair of TransActives in Stereo
The TransActive 50 has a special connector on its rear labeled "Stereo Bus Link." This
connection allows you to use a pair of TransActive monitors in stereo using a single TRS
cable to link the two TransActives together. See the diagram below for how to hook up the
speakers:
When you are using a pair of TransActives 50s in stereo, you
need to make sure your Link Channel Switch (located
directly below the Stereo Bus Link jack) is set correctly.
Your left speaker needs to be set to "Left" while the right
speaker needs to be set to "Right." If either speaker is set to
"Off" the link will not work correctly. If you reverse your
"Left" and "Right" settings, your stereo image will be flipped.
Note that in this configuration, all inputs remain active. In other words, if you have a
microphone (or keyboard) plugged into either one of your TransActive 50s, the signal will be
shared among both units and your stereo image is preserved.
Link Channel Switch
If you don't hear sound
coming out of one of your
channels when using your
TransActives in stereo, make
sure the Link Channel Switch
is set to "Left" on one
speaker and "Right" on the
other.
7