Publicité
Les langues disponibles
Les langues disponibles
The speed regulator, supplied as an accessory, must be placed in an easily accessed place, protected against impacts and away from heat sources. For
connection, comply with the diagram given inside the regulator;
Lamps, supplied separately, have to be connected to the cable (220 V single phase);
Have the system tested by a qualified electrician, if operation of the equipotential earth connection or the safety of the electrical system is in doubt,
the symbol below identifies the equipotential connection:
The Manufacturer declines all responsibilities in case of connection made by the user or unspecialized staff
WARNING!
This appliance is designed and optimized to ensure high performance and efficiency. The sole use of this appliance is to draw smoke during cooking. Any other
use is not permitted (e.g. heating food).
WARNING!
4.
MAIN RULES
The Manufacturer does not assume responsibility for faults or damage due to tampering the appliance. This appliance must be used by skilled persons that must
be periodically trained for its correct use and according to the safety regulations and prevention of accidents. Contact with hot tableware in the appliance can
cause health risks. In order to prevent them use safety equipment and act with suitable caution.
WARNING!
5.
USE OF THE APPLIANCE
Press the main switch on the supply panel that powers the appliance.
Check the efficiency of the system according to the various required specifications (electrical input, air flow, efficiency of wash system, light operation check,
etc.)
Switch off finally the main power supply line ahead of the appliance.
Clean the stainless steel surfaces inside and outside with warm water and a neutral soap, rinse thoroughly and dry carefully.
In case of long period of inactivity, store the appliance in a dry place.
6.
DISPOSAL AND RECYCLING
Dispose of the appliance responsibly and respect the environment at the end of its useful life. Proceed with its disposal in accordance with domestic regulation.
After installation dispose of the packaging according to current regulations.
Use always suitable safety equipment while handling objects
To ensure efficient operation, install the hood in an adequately ventilated
placed.
Intervention on the electric power system must be solely performed by
specialized electricians.
9
Publicité
