Sperian Fendall Pure Flow 1000 Instructions D'installation

Fendall Pure Flow 1000
Cover
behind
door
Under
handle
Cross
straps
Installation Instructions for
All manuals and user guides at all-guides.com
Protective Cover Installed
Caution: When installing the protective cover take care not to
accidently activate unit.
1. With the split in protective cover facing rear of Fendall Pure Flow,
slide cover over top and front of eyewash unit.
Make sure that the area of the cover directly above the cutout
for the activation door, is behind the activation door.
2. Tuck the sides of cover, where cover is split in rear, behind the back
of the unit on either side so that the seams meet approximately in the
center of the rear of the unit.
3. Bring door flap up to cover activation door. Slide the center tab at the
top of the door flap under the handle of the activation door and secure
the velcro strip. Secure the velcro strips on either side of the door flap.
4. On the rear of the unit, cross the top straps and bring each end of the
top strap around the front of the unit. Do not twist straps.
Insert the free end of the strap through the plastic buckle, double over
and secure velcro.
5. Repeat Step #4 for the bottom strap.
Protective Cover
®
Sperian Eye & Face Protection, Inc.
825 East Highway 151
Platteville, WI 53818 USA
1-800-336-3255
Part #32-005569 Rev. B