Zipper ZI-HS7H Mode D'emploi page 28

2.14 Troubleshooting and Fault Clearance
Problem
5. Motor does not start.
6. Wrong motor di-
rection.
7. Splitter not movIng
although motor is run-
ning.
8. Splitter working, how-
ever, with untypical
noise and vibration.
2.15 Disposal
Do not dispose your ZI-HS7H in the residual waste! Contact your local authorities for
information about best available disposal possibilities in your area. Drain fuel from the
fuel tank completely before disposing the machine. Disaggregate the machine into its
components before disposing them.
Possible Cause
1.1 No power in wall
socket.
1.2 Extension cable
defective.
1.3 Wrong supply,
400 V, three-phase
current.
1.4 Switch defective.
2.1 Wrong polarity.
3.1 Valve not opened,
caused by loose con-
nection.
3.2 Oil level too low.
4.1 Oil level too low.
Remedy
1.1 Check fuse box.
1.2 Unplug, check and use new one, if
necessary.
1.3 5-pole plug with 1.5 mm diameter.
1.4 Have it checked by electrician.
2.1 Change polarity using a screwdriver
(electrician).
2.2 Change polarity (electrician).
3.1 Tighten loose parts.
3.2 Replenish oil.
4.1 Replenish oil.
28