Publicité
All manuals and user guides at all-guides.com
2.
Attach one Serial ATA data cable to each hard drive. Then attach the other
ends of the cables to the connectors Port 1 through Port 4, on the FastTrak
card.
3.
Attach the Y-cable power splitters to each of the hard drives.
You will now use the onboard FastBuild BIOS utility to create your first array
using the attached drives. For an explanation of array options, see Chapter 3 of
the FastTrak SX4100 User Manual .
Step 3: Install the Disk Drives
Port 4
Port 3
Port 2
Port 1
5
Publicité
