Filter Replacement; Servicing; Troubleshooting Help - NateoSante Hygeolis-230 Manuel D'utilisation

FIlTer rePlACeMeNT

A light signal indicates when the filter must be changed: the red LEd on the cover
specific cases, it may be necessary to replace the filter before the signal appears, notably if you notice that
odour treatment is no longer effective.
• Open the cover to access the filter compartment. To do so, unscrew the two screws
wrench provided.
• Remove the two filter latches
• Remove the filter from the unit.
• Remove the new filter from its protective packaging and put it into place, with the blue pre-filter visible
(there are arrows on the side of the filter to indicate the air direction).
• Reset filter use by inserting a thin rod, such as paper clip or pencil tip into the reset button
LEd then goes out.
• Put back in place the filter latches then close the cover using the two screws.

servICINg

Clean your unit with a soft cloth that is slightly damp to remove dust.

TroublesHooTINg HelP

Problem(s) encountered
The unit is no longer
operating
Blue LEd on
Blue LEd on but weak
Red LEd on all the time
flashing red LEd
The red and blue LEds are
flashing and there is an
intermittent sound signal
(1 beep every 3 seconds)
The red LEd is on all
the time and there is an
intermittent sound signal
(1 beep every minute)
you can feel cool air
coming out of the unit
The remote control no
longer works.
After replacing the filter, the
red LEd continues to flash
Odours are no longer treated
17
9
.
Check that the unit is properly plugged in and that the On/Off switch is
pushed in.
Check that the unit is not in Sleep mode.
Check that the filter and the filter latches are correctly positioned and that the
cover is properly closed.
If an LEd is on, see the solutions below.
The unit is operating.
If you are not sure, change the speed. If you cannot hear the suction or cannot
feel any air coming out of the unit, check that the unit is not in Sleep mode. If
the unit still does not appear to be running, contact your dealer.
The unit is in Sleep mode. Air purification is therefore stopped.
To restart the unit, see page 15.
The filter is missing or incorrectly positioned. Insert a filter into the unit or
check that the filter present and the filter latches are correctly positioned.
The filter needs replacing. The unit has been switched off to prevent pollutants
being released back into the air. follow the instructions on page 17.
Clean Booster treatment is in progress. Evacuate the room and consult the
safety instructions on page 16.
A turbine failure has been detected. Please contact your dealer.
Cool air from the ground level is drawn up, filtered, and then propelled out.
This can make the air feel cool.
Check that the battery is correctly positioned or insert a new battery.
If this does not solve the problem, please contact your dealer.
When a new filter is installed, filter use must be reset by inserting a thin rod
into the reset button
Replace the filter according to the procedure on page17.
solution(s)
7 . The red LEd should go out.
4
flashes. In some
1
using the torx
7
. The red