Publicité
OPERATING INSTRUCTIONS
w CAUTION
1. Place the Arrowsaw on a flat, level
work surface.
2. Place the Shaft Position Bracket
onto the Base.
3. Locate the left face of the Shaft
Position Bracket at the line on the
Measuring Tape indicating the length
of shaft you want to cut. For example,
if you want to cut a 31" long arrow
shaft, locate the Shaft Position Bracket
face at the 31" mark (FIGURE 4).
4. Secure the Shaft Position Bracket to
the Base by tightening the Wing Nut.
Slowly tighten the Wing Nut while firmly
holding the Shaft Position Bracket to
prevent the Shaft Position Bracket from
moving.
5. Continue to the "THROUGH
CUTS" or "ROLL CUTS" section of this
manual.
8
Sharp Blade. To avoid severe injury keep fingers, hands
and other foreign objects clear of the saw opening Blade and
Moving Parts of the Arrowsaw. Wear approved Safety Glasses
and Kevlar Gloves when using the Arrowsaw.
Shaft
Position
Bracket
Wing Nut
Bracket
Face
FIGURE 4
Base
Publicité
