Publicité
12. Place the nock/insert end of the arrow shaft into the notch in the Shaft
Position Bracket (FIGURE 8).
13. Gently guide the end of the arrow shaft to be cut into the Cutting Blade until it
is completely cut (FIGURE 8).
14. Carefully remove the cut arrow shaft from the Arrow Shaft Guide and Shaft
Position Bracket. Be careful to not allow the arrow shaft to further contact the
Cutting Blade.
15. Turn the Arrowsaw to the 'OFF' Position. Turn off the attached vaccuum.
Disconnect from the power source when not in use.
FIGURE 8
Cutting Blade
Shaft Position
Bracket
Arrow Shaft
Arrow Shaft
Guide
10
Publicité
