Publicité
ROLL CUTS
Sharp Blade. To avoid severe injury keep fingers, hands
w CAUTION
and other foreign objects clear of the saw opening Blade and
Moving Parts of the Arrowsaw. Wear approved Safety Glasses
and Kevlar Gloves when using the Arrowsaw.
1. Set the On/Off Power Switch to the
"OFF" position. Disconnect the Power
Cord from the power source.
2. Loosen the two Thumb Screws
holding the Blade Shield to the Arrowsaw
(FIGURE 9).
3. Remove the Thumb Screws and Blade
Shield.
4. Using an Allen Wrench, loosen, but do
not remove, the Socket Head Cap Screw
securing the Arrow Shaft Guide to the
Base (FIGURE 10).
5. Adjust the Arrow Shaft Guide until the
Cutting Blade extends about halfway
through the arrow shaft (FIGURE 7).
6. Firmly tighten the Socket Head Cap
Screw to secure the Arrow Shaft Guide to
the Base.
7. Replace the Blade Shield. CAUTION:
NEVER OPERATE THE Arrowsaw
WITHOUT THE BLADE SHIELD
SECURELY MOUNTED IN PLACE!
Blade Shield
Arrow Shaft
Guide
Halfway
through
the
arrow
shaft
Arrow Shaft
Guide
Socket Head
Cap Screw
FIGURE 9
Thumb Screws
FIGURE 10
Cutting
Blade
Base
11
Publicité
