Publicité
Liens rapides
All manuals and user guides at all-guides.com
Morsø 3112 - 3142 - 3600 - 7110
Kit contents:
(1) Air duct adaptor
(2) 3.5 x 6.5 mm sheet metal screws
Installation:
1. Place adaptor flange against the shield aligning the three pre-drilled holes of the flange
to the holes on the shield.
2. Install the three sheet metal screws securing the flange to the shield.
3. Installation is now complete. You may now connect your air duct to the stove.
Floor to center of the air collar:
Morsø 3112:
317 mm (12.5")
Morsø 3142:
368 mm (14.5")
Morsø 3600:
322 mm (12.7")
Morsø 7100 - 206 mm legs: 324.5 mm (12.8")
Morsø 7100 - 276 mm legs: 394.5 mm (15.5")
If you have any further questions, please contact your authorized Morsø dealer.
Installation instructions
Air Kit Set
MORSØ JERNSTØBERI A/S . DK-7900 NYKØBING MORS
E-Mail: stoves@morsoe.com · Website: www.morsoe.com
Publicité
Manuels Connexes pour Morso 3112
Sommaire des Matières pour Morso 3112
- Page 1 All manuals and user guides at all-guides.com Installation instructions Air Kit Set Morsø 3112 - 3142 - 3600 - 7110 Kit contents: (1) Air duct adaptor (2) 3.5 x 6.5 mm sheet metal screws Installation: 1. Place adaptor flange against the shield aligning the three pre-drilled holes of the flange to the holes on the shield.
- Page 2 All manuals and user guides at all-guides.com Montageanleitung Stutzen für Aussenluftzufuhr Morsø 3112 - 3142 - 3600 - 7110 Inhalt: (1) Stutzen (2) 3,5 x 6,5 mm Schrauben Montage: 1. Den Stutzen gegen die Rückplatte halten, so dass die drei Löcher im Stutzen zu den 3 Löchern in der Rückplatte passen...
- Page 3 All manuals and user guides at all-guides.com Monteringsvejledning Friskluftstilslutning Morsø 3112 - 3142 - 3600 - 7110 Indhold: (1) Friskluftsstuds (2) 3,5 x 6,5 mm pladeskruer Montering: 1. Hold studsen imod bagpladen, så de tre huller i studsen passer med de 3 huller i bagpla- den.
- Page 4 All manuals and user guides at all-guides.com Instructions de montage Conduits airtight Morsø 3112 - 3142 - 3600 - 7110 Contenu : (1) Conduits (2) Vis 3,5 X 6,5 mm pour garniture Montage 1. Maintenir le conduit contre la garniture arrière en faisant correspondre les trois orifices du conduit aux trois orifices de la garniture arrière.