Publicité
APPLICATION :
This submersible sump pump is designed
for a permanent sump installation.
For dewatering around homes and farm. It can
be used in light commercial application.
CAPACITY :
5'
10'
15'
18'
20'
22'
IMPORTANT NOTICE
The following are minimum requirements in order to protect your residence from flooding. It is a small
investment but it is your personal responsibility to protect your home, family and valuables. Failure to
comply with the following requirements may also void your warranty :
• Two (2) pumps have to be installed in the sump pit. The first pump as a primary pump and
the second pump as the backup unit.
• Burcam alarm system model 450455 has to be installed to advise you any malfunctions.
• As sump pumps are electrically powered and activated so to prevent flooding, a Burcam
battery powered back-up pump model 300403 has to be installed to evacuate the water.
Pump selection, proper and adequate installation are a must to comply with local by-laws and need to
be adhered to.
We recommend that you install your pump in a clean location where there is
STEP 1
adequate room for servicing at a later date. Protection from freezing temperatures and
good ventilation should be considered as well, to provide the pump an environment for
long life. Do not use to pump gas or toxic fuels. This submersible sump pump is
designed to pump water only.
Friction losses in the discharge pipe must be taken into consideration when the
horizontal offset is greater than 50 feet. The discharge pipe should be increased
from 1 1/2" to 2". This will reduce friction losses and allow the pump to give
maximum performance.
More friction losses must also be taken into consideration when many elbows and
fittings are installed in the discharge line. Each elbows and fittings must be considered
as 1 feet of head.
The float switch of your pump has been pre-set at the factory and does not need
any adjustment.
Never run the pump dry. Damage to the seal may occur. Fill pump pit or sump basin
with water before turning on the power.
Assuming that you have a sump pit located in your basement floor. Your sump pit must
STEP 2
be constructed from concrete, brick, tile or more recently a sump basin made from
plastic and/or fiberglass. The minimum size of your sump pit must be 18" in diameter
and no less than 25" deep. When pit is ready, proceed to next step.
1/4 HP
1/3 HP
300508P
300600P
300700P
300601
300610
300710
300508Z
300500
300700Z
300601Z
300600Z
300710Z
300610Z
300500Z
2500
3000
2100
2500
1550
2000
550
1450
US GPH
INSTRUCTION STEPS
Please note before you proceed with the installation of this product that
the manufacturer's guideline has to be respected. Failure to comply
may void your warranty.
FEATURES :
Non-corrosive material.
Stainless steel mechanical rotary seal.
Thermal and overload protection.
Grounded electronic cables.
1/2 HP
115VAC, 60Hz.
1/4 HP 3A (7.5A when start)
1/3 HP 4A (9.5A when start)
1/2 HP 5A (12A when start)
Friction loss in
3200
pipe not included.
2850
2300
1600
1000
3
Publicité
