Publicité
EN
INSTRUCTION MANUAL
INTRODUCTION
This 4-legged transmission jack has a solid construction and a high-quality hydraulic system, which makes it ca-
pable to lift up to 500 kg in a safe and stable manner. It incorporates a pedal, which enables a quick and precise lift.
It can be used to raise, lower and transport a vehicle's engine safely.
IMPORTANT
Please read these instructions carefully.
Note the security instructions and warnings.
Do not modify the jack or use it for any application other than that for which it has been designed.
Keep the manual in a secure place for future reference.
SAFETY INSTRUCTIONS
• Make sure all preliminary checks are properly performed before using the jack. Do not use if broken, leaky
or damaged.
• Ensure the use of original parts only. Non-authorized parts may be dangerous.
• You must use the jack on level and solid ground. Keep the surface clean, tidy and free from other materials.
• Ensure there is enough oil in the cylinder to operate adequately.
• The centre of the load should be the same as the center of the transmission jack.
• In case jack turns over, stop what you are doing. Move quickly to a safe distance. Do not try to hold or steady
the jack, as it may result in a serious personal injury.
• Keep children and non-qualified personnel away from the working area.
• Never leave transmission jack unattended while being used.
• Repairing should be done by a trained professional; otherwise, it may cause personal damage.
• Never stand on the jack or use it as a ladder.
• Do not overreach. Never surpass its maximum load capacity (0.5 tones).
• Please note that common sense and caution are the main factors avoiding accidents and must be properly
applied.
PARTS
1
Support
2
Exhaust valve
3
Pedal
6
5
4
Legs
5
Wheels
6
Piston
1
2
3
4
4
ASSEMBLY INSTRUCTIONS
STEP 01
Place the two leg supports (4) on a level and stable
surface.
To verify the correct assembly of the legs, we will
ensure that the anchor screws are positioned at the
bottom.
STEP 02
Fit the four wheels (5) onto the leg supports using
the bolts, nuts, and washers.
Ensure they are securely fastened.
STEP 03
Attach the support (1) to the main piston (6).
STEP 04
Ensure the pedal (3) functions correctly.
STEP 05
Release the exhaust valve (2) to verify it operates
properly.
REF. 54001
Publicité
