Publicité
Door Height Adjustment
Use the following steps to adjust the door height, up or down,
after the doors have been leveled.
1. Open the freezer or refrigerator door. Locate the bottom hinge
and remove the door stop screw.
Classic and Architect ®Models
Remove the door stop screw from the bottom side of the
hinge with a %" open end wrench.
A
B
C
A. Bushing
B. Doorstop
screw
C. Locking plate
Overlay Models
Remove the two door sto 3 screws: one from the bottom side
using a %" open end wrench and one from the top side using
a 5/=,, Allen wrench.
4. After adjusting, check the doors to make sure they are even
at the top and bottom. If the doors are not even, continue to
turn the bushing to adjust the door height.
5. Replace the locking plate.
6. Turn the bushing slightly to align the hinge and locking plate
screw holes.
7. Replace the door stop screw or screws and tighten.
IMPORTANT: Do not place the door stop screw in the 130 °
position on Overlay Series models unless the custom panels
have been routed on the hinge side. See "Overlay Series Door
Panel & Cabinetry Clearance."
8. Make final recheck to make sure the doors are aligned and
even.
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge. See "Door
Height Adjustment"
earlier in this section.
2. Hold the door open to a position that is less than 90 °.
3. Replace the door stop screw or screws in the bottom hinge
and tighten.
J
i
A
B
A. Door stop screw from bottom
B. Doorstop
screw from top (110 °)
2. Remove the locking plate as shown.
3=
Turn the bushing located underneath the bottom of the hinge
using a r/2" open end wrench. Turning the bushing to the left
will lower the door. Turning the bushing right will raise the
door.
/
/
A
B
C
A. 130 °
B. 110 ° (Overlay series)
C. 90 °
Door-to-Door
or Door-to-Refrigerator
Trim Adjustment
1. Loosen, but do not remove, the four Torx _ 27 flat-head
mounting screws and the two 1/4"hex-head mounting screws.
2. Adjust the top hinge of either door to align it with the other
door or the refrigerator trim.
3. Tighten the four Torx ®t27 flat-head mounting screws to a
torque of approximately
100 inch-pounds
(11.3 Nm) and
tighten the two 1/4"hex-head mounting screws.
A
A. Torx '_27 flat-head mounting screws
B. ¼" hex-head mounting screws
1-L_)TORXis a registered trademark
of Textron Innovations
Inc.
24
Publicité
