Publicité
SideTrim
1/4"
(6.35
mm)
3/16"
(4.7
mrn)
11/64"
(4,5 turn)
7/32"
(5.5 mm)
1%2"(10 ram)
(15.7 ram)
Inset Installation
Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add %2" (5.6 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than 1/4"(6.35 mm) thick, route the front
edge to allow the side panel to fit into the trim.
Flush Installation
Dimensions
1. Measure the distance from point A (as shown) to the back
wall.
2. Attach the support board with a screw or adhesive that is
compatible with aluminum and wood.
Recessed
Inset Installation
Dimensions
1. Measure the distance from point A (as shown) to the back
wall.
2. Route the front edge of the support board or attach a 1/4"
(6.35 mm) board to hold the panel in the cabinet side trim.
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset or Recessed Inset panel installation.
Refrigerator
and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
•
The dimensions shown are actual product dimensions
and may not reflect the needed installation dimensions.
•
The side panel should be a minimum of 1/2"(1.27 cm) thick
to avoid warping.
•
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on rear wall.
Refrigerator
Side Trim
Overlay
t
2311/1_ ,'
(60,16 cm)
3/8"
(9.7
ram)
1/16"
_l
(1,5 mm)
v I
I
3/32"
_
!
(2.38 mm)
_-_
3/16 _'
(4.5
ram)
17
Publicité
