Intended Use - Conrad Renkforce GM107 Notice D'emploi

3. Intended Use

The LED Moving Head is used to generate light effects in light show equipment, party rooms, etc. and is
controlled by the built-in controller or an external DMX controller.
This product is only approved for connection to 110-230 V/50-60 Hz alternating voltage and only for use with
an earthed mains socket.
The DMX connection must only be connected to suitable DMX controllers or other DMX effect lights with
DMX connections.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
Any use other than that described above will damage this product and involves the risk of short circuit,
fire, electric shock, etc.
The entire product must not be modified or converted, and the casing must not be opened.
Observe all safety information in these operating instructions!
. Symbols
This symbol on the device indicates that the user must read these operating instructions before
using the product and observe them during operation.
The symbol with a lightning bolt in a triangle is used where there is a health hazard, e.g. from
electric shock. The device contains no parts that require servicing by the user. Therefore, never
open the device.
The exclamation mark indicates important notes in these operating instructions that must be
strictly observed.
The arrow symbol indicates special advice and operating information.
This symbol indicates that the product must only be used indoors.
This symbol indicates the minimum distance to the illuminated surfaces.
...m
22