Publicité
SETTING THE LCD ALARM CLOCK
PI300 is a covert DVR hidden inside of a fully functional Magnasonic LCD alarm
clock. Follow these basic steps to setup the external alarm clock portion of
your covert DVR:
To set the time:
1. Adjust the Time Switch to the mid position, this will enable time set.
2. Press the hour button to increase the time, in hours, by one.
3. Press the minute button to increase the time, in minutes, by one.
4. When you have finished setting the time, adjust the Time Switch to the
down position to prevent any adjustments.
To set the alarm:
1. Adjust the Time Switch to the up position, this will enable alarm set.
2. Press the hour button to increase the alarm time, in hours, by one.
3. Press the minute button to increase the alarm time, in minutes, by one.
4. When you have finished setting the alarm time, adjust the Time Switch
to the down position to prevent any accidental adjustments.
To enable the alarm:
1. Adjust the Alarm Switch to the up position to enable alarm.
2. Adjust the Alarm Switch to the down position to disable alarm.
PI300-SD
All manuals and user guides at all-guides.com
To turn off the alarm / use the snooze button:
When the alarm is set and enabled, an audible buzzer will sound at the set
time.
1. To turn off activated alarm, move the Alarm Switch down to disable
alarm.
2. While alarm is activated, press the snooze button to disable the alarm
for 9 minutes. After 9 minutes, the alarm will sound again and you
will again be prompted to either press the snooze button or turn off
the alarm.
NOTE: The time displayed on the LCD Alarm Clock must set
independently from the time setting on the covert DVR.
8
Publicité
