How To Use; Loading Instructions; Cleaning Instructions - INNOVA HOME CLEAN Cut Manuel D'installation

10. Once spacers are set (if necessary), hold CLEANCut and mounting bracket up and tight-
en screws into mounting holes to secure.
note: Always tighten screws to ensure the appliance does not move or shake during op-
eration. Be careful not to over-tighten the screws to avoid damaging the mounting bracket.
note: If you wish to conceal the power cord, drill a 10 mm hole through the bottom of the
cabinet floor at the rear and to the side of the cabinet. Now the power cord connector can be
run down through the 10 mm hole and connected to the power jack. The power adapter can
be plugged into a standard electrical outlet available inside the cabinet. If this outlet is not
available then one can be installed by a qualified electrician.
11. Plug power cord connector into the power jack in the back of the appliance. Plug into
standard electrical outlet. Extra cord should be hung over cord management hooks behind
unit .
[ see iLLUsTraTiOn e ]
CautIon: Make sure power cord does not fall into the roll.
12. Your CLEANCut appliance is now ready for use! For operating instructions, see the
How to uSe section of this manual.

hoW to uSe

LOaDing insTrUcTiOns

1. Pull opening latch to release the main body.
2. Push the main body down completely until it stops to ensure it is fully opened.
note: Make sure pinch rollers are recessed to completely open the insertion slot
note: The CLEANCut appliance is equipped with a security feature to prevent operation
while the unit is opened.
3. Lift dowel rod to remove from device
and dispose of empty cardboard tube
from previous use (if any).
4. Insert the dowel rod through the center
of a new paper towel roll.
5. Once paper towel roll is loaded
onto the dowel rod, place into the dowel cradle.
note: It is recommended that you place the roll into the cradle so that the paper comes up
from the bottom front of the roll
48
[ J ]
.
[ see iLLUsTraTiOn k ]
6. Load end of paper sheet through
paper path
7. Push unit up until the opening latch
clicks to securely close.
OperaTing insTrUcTiOns
1. Place hand between LED sensors in the dispense zone.
note: The CLEANCut is designed to dispense the amount of paper towel you desire. For
short sheets, briefly hold your hand in the dispense zone. For longer sheets, hold your hand
in the dispense zone for a longer period of time.
2. Once the desired amount of paper has been dispensed, remove hand.
CautIon: To prevent paper jams, do not try to remove the paper towel without cutting. The
CLEANCut is designed to give you the perfect size sheet regardless of the roll's perforation.
3. To cut, place hand between LED sensors in the cutting zone.
4. Remove cut paper towel sheet from the bottom of the CLEANCut appliance.

cLeaning insTrUcTiOns

This product contains no user-serviceable parts. Repair should be done only by authorized
service personnel.
1. Make sure the main body is opened or the power cord is removed before cleaning.
2. Small pieces of paper may remain in the paper path after numerous rolls are cut.
3. Clean with a mild, non-abrasive cleaner being careful not to soak the LED sensor windows.
[ J ].
[ k ]
.
[ k ]
49