Getting Started; Choose A Location - INNOVA HOME CLEAN Cut Manuel D'installation

gettIng Started

1. Remove all packing material.
2. Remove and save literature.
3. Unpack mounting washers, screws and spacers for mounting and set them aside in a safe
place where they will not roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed. This appli-
ance will be damaged if operated while sitting on a surface or on its side.

chOOse a LOcaTiOn

When choosing your location, consider the following:
do make sure to mount within reach of an electrical outlet.
•
do consider your normal work patterns in the kitchen when choosing location. As
•
this will become your most used kitchen appliance, it is recommended to mount the
CLEANCut close to your sink or food prep area.
do not mount over any heating or cooking appliance such as your range or oven.
•
do not mount under, in front of or behind any under-cabinet light fixtures.
•
CautIon: When selecting a location for your CLEANCut, make sure you have adequate
room to reach the power jack. Be sure to unlatch the main body to ensure that nothing hits
the power jack.
CautIon: There needs to be a minimum of 33 cm of space between the surface that the
CLEANCut is mounted to and the counter top.
DeTermine caBineT TYpe
Prior to taping the mounting template and beginning to drill your holes, determine if your cabinet has
a flat bottom or an overhanging lip
[ B ] [ c ]
tIon; if the cabinet has a lip, refer to Spacer MountIng InStallatIon.
[b]
44
. If your cabinet is flat, follow Standard InStalla-
[ c ]
flat CabInet InStallatIon
Important: Always wear protective glasses or goggles to prevent injury when drilling.
Clear counter top under installation
area to avoid getting dust or debris
on other appliances or items. Open
cabinets and remove contents to make
mounting easier.
1. Fold mounting template along Flat Cabinet Fold Line. Place template under cabinet with
fold line even against the front edge, and tape securely in place
note: Use center line to align unit with center of cabinet if desired.
Important: Do not align screw holes on template with the partition between cabinets, as
this will prevent you from installing the appliance properly. Pay close attention to where the
drill holes will be set so as not to damage your cabinets during mounting. Drilling through your
cabinet's partition may cause damage to cabinets and prevent proper installation.
2. Drill from under the cabinet up. Drill holes through the 4 places marked on the template
using a 7 mm drill bit.
Important: Always ensure you are drilling straight up through the marked mounting
hole on the template. Drilling at an angle may prevent proper installation and may damage
cabinets if the drill bit pierces the partition.
3. Once holes are drilled, remove tape and mounting template and save template with your
instructions in case you move or wish to remount at a later time.
4. Wipe dust and debris off inside cabinet surface. Also, make sure under side of cabi-
net is clean.
5. Place a washer inside the cabinet over each of the 4 holes you drilled.
6. Drop one of your screws through each of the washers covering the holes in the cabinet,
from inside the cabinet down.
7. Hold CLEANCut and mounting bracket up and tighten screws into mounting
holes to secure.
note: Always tighten screws to ensure the appliance does not move or shake during op-
eration. Be careful not to over-tighten the screws to avoid damaging the mounting bracket.
[ D ]
.
[ D ]
45