Publicité
1.
Place back (1) on a protected surface. The bottom
shelf clip should be at the bottom of the back.
(See Figure 1)
NOTE: When bolting the unit together, leave bolts
slightly loose until step 8, unless otherwise specified.
2. Bolt sides (2) to the back (1). Be sure the flanges on
sides are under the back, and that all shelf lances
point up. (See Figure 1)
Figure 1
All lances
point UP.
2
Bottom
Shelf Clips
Flange on side
1
goes under back.
3. Insert shelves (3) at your
desired levels in order to
keep the sides (2) together
before installing the top.
(See Figure 2)
NOTE: In order to place
the shelves, you must
first tilt the shelf slightly
to the left or right before
inserting into the unit.
4. Slide top (5) inside the unit. Make sure flanges of sides
(2) and back (1) go outside the top of the cabinet.
Bolt to back and sides. (See Figure 3)
Figure 3
PAGE 3 OF 9
All manuals and user guides at all-guides.com
ASSEMBLY
2
Figure 2
3
5
1-800-295-5510
uline.com
5. Bolt door and frame (6) to top (5) and sides (2).
(See Figure 4)
NOTE: Door frame must be placed over the
sides and top.
Figure 4
6
6. Insert bottom (4) from the inside of the cabinet, until
it seats on the side and rear bottom shelf clips. Bolt
bottom to the door and frame (6). (See Figure 5)
Figure 5
4
Bottom
Shelf Clips
7.
Bolt foot plates (7) into bottom of cabinet. (See Figure 6)
NOTE: The side of the foot plate with the indent
should attach to the cabinet bottom.
Figure 6
7
8. Set the unit upright and tighten all nuts and bolts
around the entire unit.
6
0921 IH-6316
Publicité
