Publicité
SMART CHARGE IUoU Chargers
2
WARNING
Please read carefully about the following precautions. Damages
caused by failure to follow the instructions below will NOT be
covered by warranty.
Use the charge only as intended:
Do not operate the charger if the housing or the cables are damaged.
o
The charger may not be used to charge any other type of batteries than
o
the ones indicated.
Do not operate the device in a damp or wet environment.
o
Do not charge a frozen battery; there is the danger of explosion.
o
Keep this charger in a safe place, out of reach of children.
o
Only qualified personnel who are familiar with the risks involved and the
o
relevant regulations should carried out maintenance or repair work.
The device must be fixed and installed in such a way that it will not fall
o
over or fall down.
3
Applications and Descriptions:
The chargers regenerate power or recharge mobile batteries used onboard
vehicles or boats
The charger can continuously charge supply batteries or starter batteries,
enabling the batteries to maintain at a high capacity level.
The charger can be used for charging three types of batteries:
Gel batteries
o
Lead-acid starter batteries
o
AGM batteries
o
Maintenance-free batteries
o
Warning!
The IUOU automatic charger lay not be used in any case for
charging other kinds of batteries (e.g. NiCd, NiMH etc.)!
Please inquire your battery supplier about the maximum capacities of your
lead-acid batteries.
The charger is equipped with a polarity protection; this prevents the charger from
being damaged in case of incorrect polarity.
An optional remote control (model number 900-RC) can be obtained in order to
11
All manuals and user guides at all-guides.com
provide remote access to the charger. Please connect the 900-RC plug in remote
control connection (figure 1 and 2).
An optional temperature sensor (model number TF-500) that is connected at the
battery being charged protects the battery against damage cause by varying
outside temperature by adapting the charging voltage of the temperature to the
battery. Please connect two ends of TF-500 as figure 9 – one end to "T.S." jack
on rear panel and another end to battery.
4
The IU0U automatic charger can deliver different unit variants. It can charge
batteries up to the specified battery capacity as indicated in the specification
(section 11).
Regarding the identification of the specification of your unit, locate your model
number in the following tables.
Rear view (see figure 3-4)
No.
1
2
3
4
5
Front view 466094 (see figure 1)
The units can charge up to two supply batteries
No.
1
2
3
4
5
6
7
SMART CHARGE IUoU Chargers
Specifications of the unit variants
Description
Connection for the temperature sensor
Unit fuse
Power switch
Connection for 230 volts supply
Ventilation outlet
Description
Half power mode button
Connection for remote control
Control lamp
Switch field for the selection of the charging voltage
and time limitation (figure 8)
"+" (plus) terminal for the supply battery (1A Charge)
"+" (plus) terminal for the supply battery
"-" (minus) terminal for the supply battery
12
Publicité
