Publicité
Clean After Use
1. Clean after each use.
2. Before cleaning and maintenance, please unplug the power cord until the
product cools.
3. Remove the lid and inner pot, clean with detergent first, then rinse wellwith
water, and wipe dry with a soft cloth.
4. Clean the internal side of the lid with water, the seal ring, block proof cover,
exhaust valve core and float valve can be removed for washing, timely and
correctly install them after washing, and then dry the internal side of lid with
cloth.
5. Wipe clean the cooker body with a rag, and it is prohibited to soak the cooker
body in water or spray water to it.
Troubleshooting
When followings occur, it is not the cooker fault, please carefully check once
before sending it for repair.
S/N
Problem
Difficult to close the lid
Difficult to open the lid
Steam leaks from the
lid
Steam leaks from float
valve
Float valve unable to
rise
Reason
Sealing ring not installed
properly
The floater valve clamps
the push rod
Float valve in the popped-
up position
Pressure exists inside the
cooker
Sealing ring installed
improperly
Food debris attached to the
sealing ring
Sealing ring damaged
The lid is not closed
correctly
Food debris on the float
valve gasket
Float valve gasket worn-out Replace the float valve
Too little food and water in
inner pot
Steam leaks from the lid or
exhaust valve
14
Solution
Position the sealing ring
well
Lightly push the push rod
Press the float valve
lightly with a chopstick.
Open the lid after the
pressure is completely
released.
Install the sealing ring as
required
Clean the sealing ring
Replace the sealing ring
Close the lid correctly
Clean the float valve
gasket
gasket
Add water and food
according to the recipe
Send to the service center
for repair
Publicité
