Operation; Main Unit Operation; Auto Operation - Sharp FU-40SE Manuel D'utilisation

OPERATION

MAIN UNIT OPERATION

The unit will start operation when the ON/OFF button is pressed.
(The unit will start operation in AUTO mode)
• During operation, the cluster ion lamp will light.
(During start of operation, the cluster ion mode will be AUTO)
The operation mode suitable for the usage condition can be set.
Stop

AUTO operation

Silent operation
Median ~ Max operation
*
Pollen removal operation
For the first 30 seconds after the power plug is inserted
into the wall outlet, the unit will check the conditions of
the air. If operation is set to ON during this time, the
Clean sign lamp will alternately flash in green, orange
and red. During this time, the Cluster ion lamp will light
blue and the unit will be in the Clean mode.
ON/OFF button
The fan level is automatically switched (High, Median, Silent) depend-
ing on the amount of pollution in the air detected by the dust sensor for
efficient air purification.
The unit will operate using little air.
The unit will operate with fan level of median, high or max.
Tobacco smoke removal operation
The unit will operate in High for 10 minutes, then the unit will return to
the AUTO mode.
10 minutes: High fan level
AUTO mode operation
The unit will operate in High for 10 minutes, then the unit will alternately
operate between Low and High.
10 minutes: High fan level
20 minutes: median level
20 minutes: High fan level
Operations available with
main unit
• AUTO operation
• Silent operation
• Median level operation
• High level operation
• Max level operation
•
*
operation
• Pollen removal operation
It can't remove the noxious
*
substances (carbon monoxide
etc.) of cigarette.
E-10
Tobacco smoke removal
Plasmacluster
Cluster ion lamp