Publicité
open the water level adjuster (WAL) fully by turning it anti-clockwise (Diagram f)
-
switch on water supply through skimmer
-
adjust the water level inside the skimmer with the feed line shut-off cock and the WAL to somewhere between the top and
-
bottom of the skimmer neck, see (Diagram g)
check the skimmer for possible damage and check the whole skimmer installation for leaks.
-
switch on the skimmer pump
-
to prevent initial over foaming and flooding of the skimmer cup, adjust the fine foam level in the cup's riser tube to the bottom
-
plate of the skimmer cup. This is achieved by turning the WAL
wait a minimum of 24 hours for the final adjustment. Turn the WAL so that the fine bubbles start bursting app. half way up the
-
cup's riser tube.
for dry foam turn the (WLA) anti clockwise, for wet foam clockwise.
-
Important: Never allow the pump to run dry.
-
f) Water level adjuster (WAL)
All manuals and user guides at all-guides.com
Starting the skimmer
g) Skimmer cup
-13-
EN
Publicité
