Maintenance And Cleaning; Accessories - Festool APS 900/2 Notice D'utilisation Originale

English
Planing
► Keeping the router away from the worktop,
set the routing depth to the maximum rout­
ing depth.
► Start routing along the long edge of the
guide slot in the routing direction (b) at the
maximum routing depth.
Proceed in the same way as with the counter­
part.
7.4 Worktop depth 900 mm
Worktops with a depth of 900 mm are machined
in two steps.
► Adjust the routing template on the alumini­
um profile until the groove on the alumini­
um profile aligns with the 900 mark on the
routing template, see magnification of fig­
ure 6A.
It is possible to machine worktops
of any other depth. To do so, move
the routing template so that it
corresponds to the chosen work­
top depth.
► Tighten the retaining screws between the
aluminium profile and routing tem­
plate [6-1].
► Align the worktop template with the bolts
on the front edge [6-3]. Align the aluminium
profile so that it is flush with the right-hand
edge of the worktop [6-2].
► Secure the lever clamps [6-4] + [6-5].
► Rout the worktop approximately up to the
centre of the guide slot (see chapter
The first part of the worktop is routed. (fig. 6B)
► Loosen the retaining screws [6-1] and open
the lever clamps on the routing tem­
plate [6-5].
► Move the routing template (c) until the
slot [6-7] is positioned off the worktop and a
bolt [6-6] can be inserted.
► Tighten the retaining screws [6-1].
► Align the worktop template with the
bolts [6-8] and secure the lever
clamps [6-5] on the routing template.
► Rout the second part of the 900 mm-deep
worktop.
The second part of the worktop is routed. (fig.
6D)
Proceed in the same way as with the counter­
part.
12
8 Routing panel joints
The recesses for the corner joints and panel
joints are routed on the underside of the work­
top.
► Align the worktop template using the bolts
(using the inner holes for 65 mm panel
joints [7-2], or using the outer holes for
150 mm panel joints [7-3]) and secure it us­
ing lever clamps.
► The locking screws [7-4] can be loosened in
order to move the panel joint templates to
the required distance on the aluminium
profile.
► Fit the router (see chapter
► Position the router and set the required
routing depth (at least half of the worktop
thickness).
► Rout the cut-outs in a clockwise direction
on both worktops to the set depth. This
should be done in multiple operations.
Use the hole in the routing tem­
plate [7-1] to position the cut-outs at
the correct distance. Turn the work­
top template without adjusting the
bolts and panel joint templates to
guarantee correct alignment on both
worktops.
9

Maintenance and cleaning

Cleaning the worktop template
► Clean the worktop template with a damp
7.3 ).
cloth.

10 Accessories

APS 900/2 spare parts
[1-3] Panel joint templates
[1-4] Bolts
[1-6] Screwdriver
The PO numbers of the accessories and filters
can be found in the Festool catalogue or on the
Internet at "www.festool.com".
11 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
Information on REACH: www.festool.com/reach
6.2 )
Item
number
493 318
493 095
466 356