Routine Maintenance - Krüger Technology KGM15020F Manuel D'utilisation Et D'entretien

The following operations must be done in order to avoid damage to the
mechanical components subjected to a heavier work load, and so as to keep
your washer performance efficient.
1) Important! When the machine is new, the pump/motor assembly must
be run in for a short period. This running in period entails not using the
machine for more than an hour and then waiting for an hour for it to
cool. Repeat this procedure 4 or 5 times.
2) At the beginning, oil must be changed after 100 hours' work; subsequently,
every 500 hours. We suggest using ISO VG F68 grade oil.
3) If the machine is not to be used for a long
period or if it might be left at a temperature
below 0°C, run the pump for a few minutes
with an antifreeze liquid through the water
suction pipe.
4) Do not suck corrosive liquids (paint, acid, solvent, oil or very dense
liquids) as these can permanently damage the pump. After you use
detergents or other similar liquids, always suck clean water to rinse the
machine out thoroughly and prevent the formation of scale.
5) At least once a month, check and clean the
water filter of the pressure cleaner.
6) Park the machine on a level floor. When not in use, keep the pressure
cleaner in a place protected from atmospheric agents.

ROUTINE MAINTENANCE

25
KGM15020F-KGM20020F