Routine Maintenance - Krüger Technology KKH20015CP Mode D'emploi

The following operations must be done in order to avoid damage to the
mechanical components subjected to bigger amount of work, and so as to
keep your washer performance efficient.
1) Important: when the machine is new, the pump/motor assembly must be
run in for a short period. This running in period entails not using the
machine for more than an hour and then waiting for an hour for it to cool.
Repeat this procedure 4 or 5 times.
2) Do not leave the machine exposed to very low temperatures. Ice can
damage the pump and seriously compromise other circuits. Empty the
circuits if the machine is parked for a long time where the temperature is
below freezing point. Make the pump run for a few minutes putting an
antifreeze liquid through the water suction pipe (A). If the temperature is
too high the motor will overheat when the machine is working.
3) Do not suck corrosive liquids (paint, acid, solvent, oil or very dense
liquids) as these can permanently damage the pump. After you use
detergents or other similar liquids, always suck clean water to rinse the
machine out thoroughly and prevent the formation of scale.
4) At least once a month, check and clean the water filter of the pressure
cleaner (B).
5) At the end of utilization put the attachments on the attachment holder (C)
and the electric cable with the gun tube on the hook (D).
A

ROUTINE MAINTENANCE

KH14011CP/KH17013CP/KH20015CP
B
27
C
D