Publicité
FIGURE (1) DELIVERY HOSE
INSTALLATION
DELIVERY HOSE INSTALLATION
(MAXIMUM SPRING TENSION)
For smoother operation during retraction and to increase hose
life, "detalc" hose by wiping entire hose length with a light lubri-
cating oil before installing on reel.
Assemble outlet adapter to hose and tighten securely. Use
teflon tape on threads to prevent leaks.
See Figure (1). Insert hose end with outlet adapter through
roller outlet and secure to axle head with U-keeper. Make sure
seal is installed correctly in axle before assembling.
To prevent damaging hose connec tions and/or components
when pull ing hose from reel, pull on the hose itself and not
on the control valve or swivel. Do not pull or jerk on the hose
when fully withdrawn from the reel.
From open side of reel, loop entire length of hose onto reel in
a clockwise direction. Pull hose out through roller outlet to wind
power spring. When hose is completely extended, latch reel to
prevent it from unwinding.
Continue to add loops of hose and pull out hose until power
spring winds tight.
Form 404109
FIGURE (2) CONNECTING HOSE
IMPORTANT
INSTRUCTIONS
Perform the following instructions as
stated to correctly set the power spring
for maximum tension.
Allow reel to retract two full revolu tions and latch reel.
Carefully unloop remaining hose from reel.
To avoid damaging reel components, always make sure
hose clamp is properly installed.
Position hose clamp so that approxi malely 1/2 loop of hose
remains on reel and latching does not occur when hose is fully
extended.
While holding hose, allow reel to retract hose until desired
height from floor is obtained, then latch reel.
Slide ball stop over free end of hose and position slightly be-
low roller outlet. Tighten screws to secure ball stop to hose.
Power spring is now set to maximum tension.
Page Number - 3
Publicité
