Publicité
How To Install
3. Determine whether there is a stud behind the
drywall where you will install the upper catch
wall bracket. Proceed to either 4a or 4b.
4a. For Drywall Without Stud / Plasterboard:
Drill a 7/32"(5.5mm) hole into the drywall at each
pencil center mark. Insert a drywall anchor into
each hole.
Use a screwdriver or drill to insert the screws
through the upper catch wall bracket into the
drywall anchor.
Drywall
Large
anchor
screw
4b. For Drywall with Stud:
Drill a 5/64" (2mm) pilot hole into the stud at each
pencil mark (no anchor needed).
Use a screwdriver or drill to insert the screws
through the upper catch wall bracket into the stud.
Large
screw
14
All manuals and user guides at all-guides.com
A
A
B
B
4a. Drywall
7/32"
5.5mm
4a. Plasterboard
7/32"
5.5mm
4b. Stud
5/64"
2.0mm
ADJUSTING BOLT ADJUSTER
TOOLS NEEDED:
• Wrench
• Hex Key
Check again that the center button on the upper and lower catch wall brackets are being
fully pressed in by the bolt adjuster. If so, use the wrench to firmly tighten the nut.
Upper catch
bracket
PLEASE NOTE: The gap between the gate to the wall should be less than 2.6" (66mm).
<2.6" (<66mm)
How To Install
Lower
catch
bracket
<2.6" (<66mm)
15
Publicité
