Publicité
ELECTRONIC CONTROL SETUP INSTRUCTIONS
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished,
but failure may occur at a later date due to ESD stress.
Use an anti-static wrist strap. Connect wrist strap to
■
green ground connection point or unpainted metal in the
appliance.
Touch your finger repeatedly to a green ground connection point
or unpainted metal in the appliance.
Before removing the part from its package, touch the anti-
■
static bag to a green ground connection point or unpainted
metal in the appliance.
Avoid touching electronic parts or terminal contacts;
■
handle electronic control assembly by edges only.
When repackaging failed electronic control assembly in
■
anti-static bag, observe above instructions.
General User Information
BLANK DISPLAY – This condition indicates the dryer is
inoperative. Enter set-up mode to view diagnostic code.
"0 MINUTES" SHOWING IN DISPLAY – This indicates the cycle
is complete and the dryer cannot be operated. Coins dropped
or debit inputs during this condition will be stored in escrow
but cannot be used until normal operation is restored by
opening and closing the door. If a door switch has failed,
it must be replaced before normal operation can be restored.
COLD START (Initial first use) – Dryer is programmed at the
factory as follows:
5 minutes dry time/quarter (coin 1)
$1.50 dry price (fixed cycle with top off – PD Models)
$0.00 dry price (fixed cycle – PR Models)
WARM START (after power failure) – A few seconds after
power is restored, if a cycle was in progress at the time of
the power failure, "RESELECT CYCLE" will flash in the display,
indicating a button needs to be pressed to restart dryer.
PRICING – After the door is opened and then closed following
the completion of a cycle, the display indicates the cycle price
(unless set for free operation). As coins are dropped or debit
inputs arrive, the display will change to lead the user through
the initiation of a cycle.
There are four (4) types of dryer pricing:
Fixed "Vend" Pricing
A dryer set up for "Fixed Cycle" operation can only accept
additional time accumulated by increments equal to the length
of a complete dry cycle. A maximum of 99 minutes may be
purchased; no additional credit is given for coins dropped
with 99 minutes in the display.
26
All manuals and user guides at all-guides.com
-OR-
Accumulator Pricing
If the price is set to one coin 1, then accumulator pricing
is in effect. Cycle time can be purchased one coin at a time
(PD models) up to the maximum time of 99 minutes. Stacked
PD models will credit all money to a cycle with a single button
press while in accumulator pricing.
Fixed Cycle With Top Off Pricing
A dryer set to offer "Top Off" capability will allow time to
be added to an existing dry cycle in increments equal to the
number of minutes of dry time per quarter (coin 1), up to 99
minutes, regardless of the cost required to start the dryer.
No credit is given for coins or debit inputs entered when the
control is displaying 99 minutes.
PR Models: In Enhanced Debit Mode, the top off price can be
set independently (see VALUE OF COIN 2), and the top off time
is calculated according to the following equation:
top off price
full cycle price
Penny increment offset is not applied to top off purchases.
FREE CYCLES – This is established by setting the cycle price to
zero. When this happens, "SELECT CYCLE" will appear rather
than a cycle price. Any cycle started as a free cycle
will automatically terminate when the door is opened.
DEBIT CARD READY – This dryer is debit card ready. It will
accept a variety of debit card systems, but does NOT come
with a debit card reader. Refer to the debit card reader
manufacturer for proper dryer setup. In models converted to
a Generation 1 debit card system, debit pulses represent the
equivalent of one coin (coin 1).
Display
After the dryer has been installed and plugged in, the display
will show "0 minutes."
Single Load Models
0
MINUTES
Once the unit has been plugged in and the dryer door opened
and closed, the display will show the price. In PR models set
for free cycles, the display will flash "SELECT CYCLE" (not
shown).
Single Load Models
PRICE
1.50
top off time
=
full cycle length
Publicité
