Tippmann TMC Série Manuel D'utilisation page 18

E
N
Mag Cleaning
G
1. Clean the outside of the magazine with a soft cloth
moistened with clean water. Do not use chemicals on
L
the magazine.
I
2. Make sure the spring mechanism is NOT compressed.
S
3. The magazine has a removable lower half. To remove
H
the lower half, remove the lower screw; this allows
the ball piston and spring assembly to be removed as
shown at right.
4. The remaining magazine assembly may be
disassembled if desired. Refer to instructions below.
5. To reassemble do these steps in reverse. Place the
spring and ball piston into magazine first, then assemble the lower panel back into
place. Secure with the screw removed in step 3.
Magazine Disassembly
Follow these instructions to disassemble and reassemble the real magazine.
1. Remove the lower screw and cover as
described in step 3 above.
2. Remove the remaining screw from the
Magazine.
3. Lift the cover off of the Magazine.
4. Inspect and clean the parts inside the
Magazine.
5. Replace any damaged or worn out parts.
6. During reassembly, make sure the Ball
Catch is oriented properly. If not, paintballs
will not feed into the marker.
7. Replace the upper Magazine half, securing with the screw.
8. Place the spring and ball piston into magazine first, then assemble the lower panel back
into place. Secure with the screw.
Magazine Lubrication
There is a small hole by the magazine detent latch located on the magazine. A single drop of
oil will ensure spring does not corrode. This spring is plated, but if left wet
it could corrode, so we recommend a small application of single oil drop
every 25 uses.
The spring wind up cord, ball piston, and ratchet wheel is an assembly.
We do not recommend disassembly of these parts. Note that the spring
is a 3 stage progressive spring to ensure even pressure and controlled
tension as the ball stack releases, as it moves around the magazine ball
channel.
18 TMC 50 Caliber Owner's Manual | Rev. 1 May 2018
d
etent