Reassembling Receiver Halves - Tippmann TMC Série Manuel D'utilisation

E
N
5. Insert the
Bumper
G
will not return. Place the Rear Bolt / Spring / Guide Pin assembly inside the right receiver
L
half. Inspect the Rear Bolt
I
S
H

Reassembling Receiver Halves

*
( indicates lubricate this part with a small amount of Tippmann Certified Marker Oil)
1. Refer to the graphics, and place the following parts into the right Receiver half:
Trigger Pins (51), black colored Sear Pin (54),
Sear (52), and gold colored Sear Spring (53).
2. Set the Trigger (49) onto the Receiver Pin 51)
as shown. Install the silver colored Trigger
Spring (50).
3. Install the Trigger Adapter Assembly (55) onto
the remaining Receiver Pins (51).
4. Slide the Front Bolt
(22).
5. Install the Linkage Arm
the Front Bolt and the Rear Bolt
The longer end of the Linkage Arm
goes towards the Front Bolt. Be sure
that the tab on the Linkage Arm fits into the slot of the Charging Handle (arrow above).
When properly assembled, they
fit together as shown in the circle
below. Ensure the Charging Handle
Spring is seated as shown by the
top arrow at right.
6. Ensure that the Gas Line (34) is
routed as shown, and fits into the receiver half. Connect the Trigger Adapter to the
Trigger with the Trigger Link Arm (48) over the Gas Line.
16
(8) and
Spring Guide Pin
(95). Ensure spring and guide pin are installed correctly. If it not, the Rear Bolt
O-Ring
10
*
(23) onto the Power Tube
*
(47) between
(7) into the
Rear Bolt
(10) for damage and replace if necessary.
9
8
7
50
*
(9).
s
pring properly seated
TMC 50 Caliber Owner's Manual | Rev. 1 May 2018
(9). Next install the Rear Bolt
95
51
55
48
49
53
52
54