Marker Disassembly Instructions - Tippmann TMC Série Manuel D'utilisation

E
N

Marker Disassembly Instructions

G
Set up a workbench with plenty of workspace to make sure no small parts become lost.
L
Always wear eye protection (like safety glasses) when performing any marker disassembly
I
or re-assembly.
are in parentheses). When disassembling the marker, pay close attention to how the parts fit
S
together to make later re-assembly easier and accurate. These illustrations show the hopper
H
fed marker, but apply to the magazine fed marker as well.
1. Follow
Unloading Your Marker
on page 12. Make sure there isn't a paintball in the chamber.
2. Put the marker into the uncocked position. Set the
the Fire mode. Pull the Trigger to release the bolt.
3. Remove the
it, turn it clockwise to thread it into the Receiver. Make sure the
with Tippmann Certified Marker Oil when re-assembling the barrel to the marker.
4. Remove the
5. Remove the
Feed Tube and swing it out to remove it from the marker. You must remove the Feed
Tube to remove the fake magazine from the marker.
6. Remove the
(45) in, and slide the magazine out the bottom of the marker. The fake magazine
Button
contains the ball latch. If converting to Magazine Fed, the fake magazine needs to be
removed.
7. Remove
Screw
from the marker.
8. Remove the remaining Receiver Screws (41, 42, and 46) shown above. Remove Screw
(59) from the right side Grip. Remove both Grips from the marker. Pull straight down on
the
ASA
9. Put the Safety Selector Switch in the Fire position (as shown above) and pull in the
Trigger. While holding the Trigger in, place one hand inside the magazine well and
carefully lift the left-side receiver to access the internal parts. The Safety Selector
Switch and Magazine Release mechanism stay with the left Receiver Half.
14
Refer to the Parts Diagram for these instructions
(27), turn the Barrel counterclockwise from the Receiver. To reinstall
Barrel
(92) from the marker.
Rear Sight
Feed Tube Assembly
, from the right side of the marker, press the
Magazine
(41A) from the left side of the marker. Pull the Front Shroud assembly
41a
(32) to remove it from the Gas Line (34).
on page 10 and
Air/CO2 Cylinder Removal
Safety Selector Switch
(66). Unscrew the
92
46
39
41
42
TMC 50 Caliber Owner's Manual | Rev. 1 May 2018
(item numbers
instructions
(26) is lubricated
O-Ring
(65) from the
Locking Cap
Magazine Release
46
42
32
(39) to