Publicité
All manuals and user guides at all-guides.com
Quick Start
5. Connect the D-SUB cable to D-SUB connector on the back of the monitor (Figure C.2).
6. Replace connector cover.
NOTE: Incorrect cable connections may result in irregular operation, damage display
quality/components of LCD module and/or shorten the module's life.
7. Connect one end of the power cord to the AC Adapter and the other end to the power outlet
(Figure E.1) (Figure G.1).
8. Turn on the monitor (Figure F.1) and the computer.
9. To complete the setup of your MultiSync LCD monitor:
A. Set the resolution to 1600 x 1200 @ 60 Hz.
NOTE: For download information on the Windows
95/98 INF file for your MultiSync LCD
monitor,refer to the References section of
this User's Manual.
B. Use the following OSM
• Auto Adjust Contrast (
• Auto Adjust (
• Image Adjust – Fine (
NOTE: Manual adjustment of the H/V Position and
Image Adjust H. Size/Fine controls may be
required to complete setup of your MultiSync
monitor. For a full description of these OSM
controls, refer to the Controls section of this
User's Manual.
10.Refer to User's Manual in the NEC LCD Setup
Software CD case for installation and operation
of this software.
NOTE: If you have any problems, please refer to
the Troubleshooting section of this User's
Manual.
Power
Button
Figure F.1
LCD2110usersmanual
–continued
®
controls:
™
)
AUTO
)
)
Clip
A
Clip
B
Figure D.1A
Figure D.1B
4
6
R
G(/SYNC)
B
HS/CS
VS
Figure C.1
Figure C.2
Figure E.1
Figure G.1
4/23/01, 10:43 AM
Publicité
