Publicité
2.0 S
AFETY
W
WARNING! Risk of serious injury or damage
• The cushion is designed to be used only at room temperature. If it is left at lower
temperatures, always allow it to warm to room temperature before using. Sitting on
extremely cold or hot surfaces can cause skin damage.
• Avoid sharp objects or exposure to excessive heat or open flame.
• DO NOT smoke while using this device.
W
WARNING! Risk of injury or damage
Invacare® Matrx® products are specifically designed and manufactured for use in
conjunction with Invacare® Matrx® accessories. Accessories designed by other
manufacturers have not been tested by Invacare® or Motion Concepts and are
not recommended for use with Invacare® Matrx® products.
For information and/or to purchase Invacare® Matrx® accessories, contact
Motion Concepts or Invacare by phone, or online at www.motionconcepts.com
or www.invacare.com.
3.0 C
USHION
3.1 Installing the cushion
WARNING! Risk of Serious Injury or Damage
W
A
An improperly installed or secured cushion could cause loss of stability resulting
in serious injury or damage.
1. Remove all packaging before installation.
2. If applicable, ensure the desired fabric surface of the outer cover is exposed. Refer
to section 3.2 - Reversing the outer cover below.
3. Orient the cushion so the waterfall edge is facing the front of the wheelchair and
the hook and loop strips are facing down.
4. Align the loop strips on the bottom of the cushion with the corresponding hook
strips on the wheelchair seat.
5. In the event that the wheelchair seat and PS Cushion have matching loop strips,
install the four double hook strips (provided separately) at each of the intersection
points on the wheelchair seat to secure the cushion in place.
6. Position the cushion onto the wheelchair as far back as possible.
7. Press down firmly to ensure the hook and loop strips are fully engaged.
3.2 Reversing the outer cover (StarTex™ fabric only)
IMPORTANT! The optional Kidabra, Pink and Blue outer covers are non-
reversible – DO NOT use these outer covers turned inside out.
1. Unzip and remove the outer cushion cover.
2. Turn the outer cushion cover inside out so the desired fabric surface is visible.
3. Re-install the foam cushion (with inner cover) into the outer cover, ensuring that the
waffled recess in the foam faces down and the rounded (radius) cushion edge faces the
zipper opening..
I
NFORMATION
S
-
ET
UP AND
(...cont'd)
I
NSTALLATION
- 6 -
Publicité
