Publicité
SAFETY INSTRUCTIONS:
•
This charger is designed to charge only 6 and 12V batteries. Do not use for any other
purpose. Always follow the battery manufacturer's recommendations.
•
Always check the charging cables of the charger before use. Ensure that the cables are
intact, without signs of wear, breakage, or bending. Charging with damaged cables
is strictly prohibited. If the cables are damaged, replace them with identical cables at
specialized centers.
•
Do not recharge a non-rechargeable battery.
•
Do not charge a damaged battery.
•
Do not charge a frozen battery.
•
Do not place the charger on the battery during charging.
•
Ensure the location is well ventilated during charging.
•
Do not cover the charger during charging.
•
During the charging phase, explosive gases may form. Do not create sparks near the
charging area. When the battery reaches the end of its life, there is a risk of internal
sparking.
•
Do not leave the charging area unattended for a long time. Perform regular checks at
intervals.
•
It is prohibited to put the cables in contact with hot or sharp surfaces.
•
The battery electrolyte is corrosive. In case of contact with skin or eyes, rinse thoroughly
and consult a doctor.
•
Leaving the charger unattended and connected to the network for a long period is
allowed only if the battery is fully charged. If the charger is not set to the charging mode
for 50 hours, it signals an error. In this case, the charger must be set manually.
•
Battery fluid evaporates during charging. Regularly check the electrolyte level. If the
level is low, add distilled water.
•
This device should not be used by children or persons unable to understand this
manual. Keep the device out of the reach of children.
•
A fuse on the PCBA prevents overload, the maximum AC input current is 3.15 A.
NOTES: If the "ERROR" indicator lights up: the cables are not correctly connected to the poles
or the battery is out of service. If the "CHARGE" indicator lights up, the charger is in operation
and charging.
NOTE FOR BATTERIES INSTALLED ON VEHICLES: Connect the red cable to the positive
terminal of the battery. Connect the black cable to the ground, away from any electrical
source. Plug into the power outlet. Disconnect the charger from the power outlet before
removing the cables. Disconnect the black cable first and then the red one.
THE POSITIVE TERMINAL OF THE BATTERY IN SOME VEHICLES MAY BE GROUNDED.
Connect the black cable to the negative terminal of the battery. Connect the red cable to
the vehicle ground away from heat sources or electrical parts. Plug into the power outlet.
Disconnect the charger from the power outlet before removing the cables. Disconnect the
black cable first and then the red one.
Publicité
